Teac HS-2000 - Manual (Page 75)

TASCAM HS-2000
75
8 – Take mode
7. On the
TAKE T/C
screen, use the
FRAME EDIT
but- ton to set whether or not to edit the frame value.
Frame editing on
Frame editing off
8. Use the number buttons to input the take start time.
If you begin input without selecting a unit, input will •
start from the smallest one.
To input a specific unit, touch it to make its background •
yellow, and then use the number buttons or the DATA
dial to enter two digits at a time.
Touch the • CLEAR button to set all values to 00.
9. Touch the
ENTER
button to confirm the setting.
TIP
This can also be edited using an external keyboard. •
Press the keyboard’s ESC key to clear all values (set •
them to 00).
10. When a confirmation pop-up appears, touch the
OK
button or press the DATA dial.
Exporting takes
You can export takes from the current session to the
following destinations.
Root of the same CF card •
Root of another CF card •
Current session of another CF card •
1. Select the take you want to export on the take selection
screen.
2. Touch the
MENU
button on the take selection screen
to open a pull-up menu.
3. Touch the
EXPORT
button in the pull-up menu to
open the following pop-up window.
Touch the button for the desired destination to export
the take to it.
Touch the
OK
button or press the DATA dial to export
the se- lected take.
Touch the
CANCEL
button on the pop-up window to
return to the take list screen.
NOTE
If the export destination is empty (no current session •
when CFn Current selected) the same project/session
structure as the source will be created automatically
during the export.
If the export destination contains a file with the •
same name, exporting will fail and a pop-up appears
warning, “Selected Take Already exists in Export
destination.”
If the total size of the export file exceeds the free space •
of the export destination, exporting will fail and a pop-
up appears warning, “Cannot EXPORT. Not enough
space on CFn.”
If sampling frequency of the export destination •
project differs, exporting will fail and a pop-up
appears warning, “Cannot EXPORT. Destination Project
is different Fs.”