Super Systems PC Configurator 2 - Manual (Page 48)

Super Systems Inc. Page 48 of 201 Configurator Manual #4562 Rev D
The user can select the input to perform the trim on from the “Input:” box. The user can enter
the cold junction offset in the “Offset:” box. The current cold junction value will be displayed
next to the “CJ:” line. Also, the current values from the selected inputs will be displayed on the
right of the tab. To display an input’s value on the “Cold Junction” tab, click on the “Zero/Span”
tab and check that input’s checkbox, then return to the “Cold Junction” tab. Click on the
Calibrate button to begin the calibration.
Click on the Done button to close down the screen.