Super Systems PC Configurator 2 - Manual (Page 131)

Super Systems Inc. Page 131 of 201 Configurator Manual #4562 Rev D
Aux Setpoint Configuration
Configurator – Aux Setpoint Configuration menu option
See the menu option
Slave Instruments for configuration prior to using Aux Setpoint
Configuration . This menu option allows for up to 3 slave instruments to have the setpoint
retransmitted from one of the three control loops. This menu option is typically used to
retransmit an alarm setpoint value to an overtemp controller.
Offset:
Carbon - 1 = 0.01
Temperature – 1 = 1
Delay:
This is measured in seconds
Clicking on the values for “Retrans To Slave 1”, “Retrans to Slave 2”, or “Retrans to Slave 3” will
display an input box with a drop-down list from which the user can select the new value. The
options are:
Off
Loop
1
Loop 2
Loop 3
Clicking on any of the values for “Setpoint Offset SI 1”, “Setpoint Offset SI 2”, “Setpoint Offset
SI 3”, “Setpoint Delay SI 1”, “Setpoint Delay SI 2”, or “Setpoint Delay SI 3” will display an input
box from which the user can select the new value. The range is –32768 to 32767.