Super Systems PC Configurator 2 User Manual
Page 11
Super Systems Inc.
Page 11 of 201
Configurator Manual #4562 Rev D
The “Ethernet” option specifies the IP Address of the controller. Clicking on the scan button
next to the text box,
, will allow the user to scan the network for all available devices with
the
SSi Device Selector
screen.
Configurator – SSi Device Selector
Clicking on the Scan button will initiate the scan procedure. Please note that this scan could
take a few minutes. Once the scan has completed, the list of available devices will be
displayed. Clicking on one of the devices will highlight that line in
blue
. Clicking on the OK
button once a device has been selected will set that device’s IP address in the Ethernet IP
address textbox. Clicking on the Cancel button will cancel the process and close down the
SSi
Device Selector
screen.
The “Serial” option specifies the “Com Port” (COM1 – COM20), the “Baud” rate (1200 –
115200), and the “Address” (0 – 250).
The “SuperData” option specifies the channel for SuperData (1 – 128).
The “Chart File” specifies the chart file (.ctm) to be used. Clicking on the open button,
, will
display a Windows open file dialog box that will allow the user to navigate to the proper
location, if necessary.
Check the checkbox next to “Display on overview” if you want to display this on the
Overview
Display
screen.
Clicking on the Menu button will allow the user to set up the menu options for each access
level.