Super Systems 9205 Series - Manual (Page 96)

Series 9205 Operations Manual Rev A 95
UMC800 LP1
SSi Quad AO1
SSi Quad AO2
SSi Quad AO3
SSi Quad AO4
Yokogawa UT350
Yokogawa 750 Lp 2
Yokogawa UP350
Honeywell DCP551
Ascon 08
SSi X5
SSi M4L
SSi X5/Timer
SSi SPUD
SSi AIB3
SSi H2 Cell
Flow Meter Short
SSi O2 Remote
SSi Dual Motor Board
SSi Smart AIB 3
O2 Block
Waukee Valvetronic+
SSi eSPP
EL-Flow
SSi AC E
Yokogawa 750E
Mod Mux
Dualpro E Modbus
Dualpro E MMI
Carbpro E v3.5
Carbpro E v3.0
Eurotherm 2500
SSi 8-8
SSi 9200 E
Micrologix PLC
MCM Module
PLC DF1
SLC DF1
User 1
User 2
User 3
User 4
User 5
User 6
User 7
User 8
User 9
User 10
User 11
User 12
User 13
User 14
User 15
User 16
Some instruments may not be shown in the list of instruments. User Instruments 1 through 16 are used to
set up a non-listed instrument as a slave instrument using the Generic Instrument Setups menu.
Address
This value allows the user to select the address that corresponds with the controller selected, with a range
of 0 to 249.
Port
The options for this field are: Slave 1, Slave 2, RS-232, IP Address 1, IP Address 2, IP Address 3, IP Address
4, Passive, or Slave 3/RS-232.
Slave 1 – terminals 5(-), 6(+)
Slave 2 – terminals 22(+), 23(-)
RS-232
Zone Assignments
A zone assignment on the 9205 controller
allows the recipe programs to change
setpoints on all slave instruments of a
multi-zone furnace (up to 10 zones).
WARNING: This screen should not be
changed without consulting SSi at 800-666-
4330.
*Only used when running recipes
*Slave Instrument Setup must be configured prior to Zone Assignment setup
* Temperature zones link instruments to Temperature Setpoints
The zone assignment feature allows the Series 9205 program to change setpoints on all instruments of a
multi-zone furnace. The Series 9205 has up to five temperature zone assignments available (Zone
Assignment 1 – Zone Assignment 5) on two programmers. The Series 9205 programmer looks for