Super Systems 9205 Series - Manual (Page 191)

Series 9205 Operations Manual Rev A 190
Field Factory Default Value
Temp Wait Limit 0
Atm Wait Limit 0.00
Furnace Name
Alarm 1 Setup
Setpoint 10
Alarm Type PV1 NC/in band
Hysteresis 1
Smart Alarm disabled
ON Delay Time (sec) 0
0 SP blocks alarm no
BO/Impedance inhibits alarm no
Inhibit source none
Disable on open input no
Alarm 2 Setup
Setpoint 15
Alarm Type PV2 NC/in band
Hysteresis 1
Smart Alarm disabled
ON Delay Time (sec) 0
0 SP blocks alarm no
BO/Impedance inhibits alarm no
Inhibit source none
Disable on open input no
Alarm 3 Setup
Setpoint 1400
Alarm Type IN3 proc high
Hysteresis 1
Smart Alarm disabled
ON Delay Time (sec) 0
0 SP blocks alarm no
BO/Impedance inhibits alarm no
Inhibit source none
Disable on open input yes
NOTE: The default setting for the process alarm is 1400°F. By default, this alarm is triggered by input 3
unless the 9205 is controlling % Carbon with a dual thermocouple setup, in which case the alarm is
triggered by input 2.
Relay Assignments
Relay 1 loop 2 fwd
Relay 2 loop 1 fwd
Relay 3 loop 1 rev
Relay 4 burn off
Relay 5 alarm 1
Relay 6 alarm 2
Relay 7 event 0