Super Systems 9205 Series - Manual (Page 123)

Series 9205 Operations Manual Rev A 122
C 40mV
E 80mV
J 80mV
K 80mV
N 80mV
NNM 80mV
R 40mV
S 20mV
T 20mV
Click the Done button to close the screen down.
Auxiliary Input Offset Correction
This menu option will allow the user to enter offsets
for the auxiliary inputs and apply any correction curves
as needed. The offset can be in degrees + or -, and it
is typically used to compensate for incorrect T/C wires.
Enable Offsets for SSi AIB
This will enable the use of offsets for any analog input
boards. The options are: Yes or No.
Input 1 – Input 40
This is where the actual offsets will be entered for
each input. The range is -50.0 – 50.0.
Input 0 Correction – Input 39 Correction
This is where any correction curve can be applied for
each input. Note – The input names for the corrections
are offset by 1, so Input 0 is actually Input 1, Input 39 is
actually Input 40, etc . The options are: Not Used,
Curve 1, Curve 2, or Curve 3.