Super Systems 9205 Series - Manual (Page 182)

xSeries 9205 Operations Manual Rev A 181
Appendix D – 9205 Instrument Alarms
This appendix provides a list of alarms programmed into the 9205 controller. The table below provides the alarm name, alarm text (as presented
in Configurator), the condition(s) under which the alarm is generated, and information on user-accessible settings that affect the triggering of the
alarm.
Alarm Description Register/Bit Location Type Values Alarm Condition(s) Applicable User-
Configurable Setting(s)
Programmer (any) alarm 141/0 Programmer
Alarm 1 141/1 Main
Alarm 2 141/2 Main
Alarm 3 141/3 Main
TC redundancy alarm 141/7
Internal System Error 141/8
Analog input CPU is no
longer responding to the
9205's main CPU.
TC Check 1->2 out of band 141/9
TC Check 1->3 out of band 141/10
TC Check 2->3 out of band 141/11
End of Quench 141/12
Programmer 2 (any) alarm 141/14
Slave coms (any) alarm 141/15
TC rise too great 163/0 Burnoff
mV insufficient drop 163/1 Burnoff
slow recovery 163/2 Burnoff
impedance too high 163/3 Burnoff
PLC Alarms (custom) 2980 - 2989 PLC
user alarm 25024/0 Programmer
deviation, atmosphere 25024/1 Programmer
high atmosphere 25024/2 Programmer
low atmosphere 25024/3 Programmer
deviation, temperature 25024/4 Programmer
high temperature 25024/5 Programmer
low temperature 25024/6 Programmer
high atm % output 25024/7 Programmer
low atm % output 25024/8 Programmer
high temperature %
output 25024/9 Programmer
low temperature % output 25024/10 Programmer