Super Systems 9205 Series - Manual (Page 74)

Series 9205 Operations Manual Rev A 73
Exponential
The Exponential field will determine if there is an exponent value. For “Integer” Input Types, exponents do
not apply, so this field is not modifiable. If the Input Type is not “Integer”, the options for the exponential
are: Yes or No. This will cause the Scaler to be a power of 10.
Input Scaler
The Input Scaler field will determine the input scaler range. The Scaler is a power of ten in the range -30 to
+30.
Output Type
The Output Type will determine what kind of the output value will be. The options are: Integer, Big Endian,
Big Endian Byte Swap, Little Endian, or Little Endian Byte Swap.
Exponential
The Exponential field will determine if there is an exponent value. For “Integer” Input Types, exponents do
not apply, so this field is not modifiable. If the Input Type is not “Integer”, the options for the exponential
are: Yes or No. This will cause the Scaler to be a power of 10.
Output Scaler
The Output Scaler field will determine the Output Scaler range. The Scaler is a power of ten in the range -
31 to +31.
DF1 Configuration
This option allows the information data from the 9205 to
be sent to the PLC DF1 Register map.
My Node:
This option will allow the user to select the node. This
node must not exist anywhere else on the computer’s
network. The range is 0 to 30000.
PLC node:
This option will allow the user to select the PLC node.
This must be the node address of a PLC. The range is 0 to
30000.
PLC read table:
This option will allow the user to select the PLC read table. The range is 8 to 255.
PLC write table:
This option will allow the user to select the PLC write table. The range is 8 to 255.
PLC intermessage delay:
This is the delay time (in milliseconds) between requests sent to the PLC from the 9205 controller. The
request can be for any read or write transaction between the PLC and the 9205. The range is 51 - 5000.