Super Systems AC20 User Manual
Page 98
A. 2
The following is a list of the default run time parameters loaded
during the above procedure:
Run time group 1 [R.Axx]
Run time group 1 [R.Axx]
Run time group 1 [R.Axx]
Run time group 1 [R.Axx]
Run time group 1 [R.Axx]
PARAMETER
DEFAULT VALUE
SP
= Set point low limit ("rL" [R.E10])
SP2
= Set point low limit ("rL" [R.E10])
SP3
= Set point low limit ("rL" [R.E10])
SP4
= Set point low limit ("rL" [R.E10])
COF
= 200
H2F
= 400
Run time group 3 [R.Cxx]
Run time group 3 [R.Cxx]
Run time group 3 [R.Cxx]
Run time group 3 [R.Cxx]
Run time group 3 [R.Cxx]
PARAMETER
DEFAULT VALUE
ñ.rSt
= OFF
AL1
= Initial range value (for process alarm)
= 0 (for deviation alarm)
bA1.L
= -10
bA1.h
= 10
AL2
= Initial range value (for process alarm)
= 0 (for deviation alarm)
bA2.L
= -10
bA2.h
= 10
AL3
= Initial range value (for process alarm)
= 0 (for deviation alarm)
bA3.L
= -10
bA3.h
= 10
HSA1
= 1
HSA2
= 1
HSA3
= 1
Run time group 4 [R.Dxx]
Run time group 4 [R.Dxx]
Run time group 4 [R.Dxx]
Run time group 4 [R.Dxx]
Run time group 4 [R.Dxx]
PARAMETER
DEFAULT VALUE
Pb
= 10.0 % (if PID control is configured)
= 15.0 % (if PI control is configured)
HYS
= 0.5 %
ti
= 1.50 mm.ss (if PID control is configured)
= 2.45 mm.ss (if PI control is configured)
td
= 1.00 mm.ss
IP
= 50.0 (If only one control output is configured).
0.0 (If two control outputs are configured).
r.Gn
= 1.00
OLAP
= 0
Run time group 5 [R.Exx]
Run time group 5 [R.Exx]
Run time group 5 [R.Exx]
Run time group 5 [R.Exx]
Run time group 5 [R.Exx]
PARAMETER
DEFAULT VALUE
ArW
= 100%
ñ.OLL
= 0.0%
ñ.OLH
= 100.0%
ñ.rñP
= Inf
ac20-ssi-A.pmd
19/12/2003, 9.11
2