Super Systems AC20 User Manual

Page 34

C.F05 - Main control output full scale value

C.F05 - Main control output full scale value
This parameter is available only when "ñ.SCL" ("Main control
output in engineering units" [C.F02]) is set to "YES".
Upper display: CnF.3
Lower display: ñC.E.H
Range: from -199 to 999

C.F06 - Main output auxiliary conditioning

C.F06 - Main output auxiliary conditioning
This parameter is available only when main control output is
configured and “ñC.Cn” ("Main control output conditioning"
[C.F01]) is different from “norñ”.
Upper display: CnF.3
Lower display: ñC.A.C
Range: bEFr = The functions listed at Note (A) are calculated

before

before to apply the action selected by “ñC.Cn”
("Main control output conditioning" [C.F01])
parameter.

AFtr

= The functions listed at Note (A) are calculated

after

after to apply the action selected by “ñC.Cn”
(“Main control output conditioning” [C.F01])
parameter.

Note (A)

Note (A)
- "Main control output limiters" - for more details see [r.E02] and

NOTE

NOTE: This scaling allows you to display the output value in
engineering units instead of in percent.

C.F03 - Main output decimal point position

C.F03 - Main output decimal point position
This parameter will be available only when "ñ.SCL" ("Main control
output in engineering units" [C.F02]) is set to "YES".
Upper display: CnF.3
Lower display: ñC.dP
Range: ---.

= No decimal figure

--.-

= One decimal figure

-.--

= Two decimal figures

C.F04 - Main control output initial scale value

C.F04 - Main control output initial scale value
This parameter is available only when "ñ.SCL" ("Main control
output in engineering units" [C.F02]) is set to "YES".
Upper display: CnF.3
Lower display: ñC.E.L
Range: from -199 to 999