beautypg.com

Super Systems AC20 User Manual

Page 100

background image

A. 4

DEFAULT CONFIGURATION

DEFAULT CONFIGURATION

DEFAULT CONFIGURATION

DEFAULT CONFIGURATION

DEFAULT CONFIGURATION
PARAMETERS

PARAMETERS

PARAMETERS

PARAMETERS

PARAMETERS

A complete and consistent set of configuration parameters is
stored in the instrument. These data are the typical values
loaded in the instrument prior to shipment from factory.
When it is desired to load the default value of all the configura-
tion parameters, proceed as follows:

If the instrument starts in configuration mode, push the MENU
pushbutton.
If the instrument starts in run time mode, by keeping depressed
the MENU push-button for more than 5 seconds the instrument
will show:

NOTE

NOTE

NOTE

NOTE

NOTE: If no push-button is depressed for more than 10 s
(or 30 s according to "CnF.6" "t.out" [time out selection" C.I10]
parameter setting), the instrument returns automatically to the
normal display mode.

By V or W push-button select "ñodF."

NOTES

NOTES

NOTES

NOTES

NOTES:
1) When modify mode is started, the instrument stops the

control and:
- sets to OFF the control outputs;
- turns to OFF the bargraph displays;
- sets analog retransmissions to the retransmitted initial

scale value;

- sets to OFF the alarms;
- disables the serial link;
- removes the time out.

2) When the modify mode is disabled by V101 (SW3), the V or

W

push-button pressure has no effect.

Push MENU pushbutton again and select the "Default
configuration group" [C.Cxx].
NOTE:

NOTE:

NOTE:

NOTE:

NOTE: if the configuration parameters are protected by security

code, by V or W pushbuttons set the security code
assigned and press the FUNC pushbutton.

By V or W push-button select the desired configuration
parameter set "tb.1" (european) or "tb.2" (american)
Push MENU pushbutton again
The central display will show:

ac20-ssi-A.pmd

19/12/2003, 9.11

4