Super Systems AC20 User Manual
Page 20

18
Run time groups protected by security code
Run time groups protected by security code
Run time groups protected by security code
Run time groups protected by security code
Run time groups protected by security code
The display will show:
By this parameter it is possible to set if the run time group 1 will
be protected or not by the run time security code.
By and push-button, set "Gr1" parameter as follows:
nO
No protection (it is always possible to modify run time
group 1 parameters).
Yes
the run time group 1 parameter modification will be
protected by security code.
Push the FUNC push-button; the instrument memorizes the new
setting and goes to the next parameter.
NOTES
NOTES
NOTES
NOTES
NOTES: 1) This selection may be performed only if a run time
security code has been set (from 2 to 250).
2) The above described selection may be repeated for
all groups of the run time mode.
Run time security code
Run time security code
Run time security code
Run time security code
Run time security code
The display will show:
Note
Note
Note
Note
Note: the middle display shows the current status of the run
time security code ("0", "1" or "On").
By and push-button, set "S.run" parameter as follows:
0
No protection (it is always possible to modify all run
time parameters);
1
always protected (it is never possible to modify a run
time parameter);
from 2 to 250 security code for run time parameter
protection.
NOTES
NOTES
NOTES
NOTES
NOTES:
1) The selected value of a security code cannot be displayed
anymore and, coming back to the "S.run" parameter, the display
will show "On" when "S.run" is different from 0 or 1, "0" when
"S.run" is equal to 0, "1" when "S.run" is equal to 1.
When the security code is forgotten, a new value can be set.
2) When "S.run" is different from 0 or 1, the "run time default "
and the "run time hidden" groups are always protected by
security code.