Super Systems AC20 - Manual (Page 46)

44
e) Pushing FUNC push-button again, it is possible to display the
Carbon potential, the "CP" LED lights up.
NOTE:
NOTE: NOTE: NOTE: NOTE: this selection is available:
- if Carbon potential or O2 are not selected as
controlled variable,
- even if a measure error is shown on the upper
display,
- even if a Burnoff or Probe test procedure is in
progress.
f)Pushing FUNC push-button again, it is possible to display the
Carbon monoxide factor value, the "COF" LED lights up.
g) Pushing FUNC push-button again, it is possible to display the
Hydrogen factor value, the "H2F" LED lights up.
h) Pushing FUNC push-button again, it is possible to display the
Probe resistance value, the "K Ω " LED lights up (the graphic
symbol " " shows that the Probe resistance value is
greater than 99.99 K
Ω ).
i) Pushing FUNC push-button again, it is possible to display the
Probe response time, the "SEC" LED lights up.
l) Pushing FUNC push-button again, it is possible to display the
Probe temperature at last probe test, the "LT" LED lights up.
m)Pushing FUNC push-button again, it is possible to display the
Carbon monoxide value, the display will show "CO." followed
by the value measured on the auxiliary input (the graphic
symbol " " shows that its value is more than 99).
2)if the device is configured with two control outputs; the
value of the MAIN output is shown on the two most
significant digits, while the value of the SECONDARY
output is shown on the two less significant digits.
The decimal point between the two values will be flashing.
The graphic symbol “ “ shows that the specific
control output is > 100%.
b) Pushing the FUNC push-button; it is possible to display the
sensor output in mV, the "mV" LED lights up.
NOTE:
NOTE: NOTE: NOTE: NOTE: this selection is available:
- if "mV" is not selected as controlled variable,
- even if a measure error is shown on the upper
display,
- even if Burnoff or Probe test procedure are in
progress.
c) Pushing FUNC push-button again, it is possible to display the
sensor temperature, the "TP" LED lights up.
d)Pushing FUNC push-button again, it is possible to display the
Dew point value, the "DP" LED lights up.
NOTE:
NOTE: NOTE: NOTE: NOTE: this selection is available:
- if Dew point or O2 are not selected as controlled
variable,
- even if a measure error is shown on the upper
display,
- even if Burnoff or Probe test procedure are in
progress.