Super Systems AC20 User Manual

Page 29

C.D09 - TIME CONSTANT FOR FILTER ON REMOTE

C.D09 - TIME CONSTANT FOR FILTER ON REMOTE
SETPOINT VALUE (CnF.1)

SETPOINT VALUE (CnF.1)

SETPOINT VALUE (CnF.1)
Lower display:

A.I.FL

Range:

From 0(filter OFF) to 8 s

Available:

When auxiliary input is used as remote

set point
Note: First order filter with selected time constant

C.D10 - REMOTE SETPOINT ACTIVITY MODE (CnF.1)

C.D10 - REMOTE SETPOINT ACTIVITY MODE (CnF.1)
Lower display:

A.I.Añ

Range:

norñ = The remote set point is

activated by external contact(or is always activated if none
contacts are configured for this feature) and the value is limited
at its min/max value when out of range
Cnd.A = The remote set point
activation is controlled by status of auxiliary input.
(The device works with local set point when auxiliary input is
out of range while it works with remote set point when auxiliary
input is in range)
Available: When auxiliary input is used as remote set point

C.D11 - LOCAL / REMOTE SETPOINT OPERATING

C.D11 - LOCAL / REMOTE SETPOINT OPERATING
MODE (CnF.1)

MODE (CnF.1)

MODE (CnF.1)
Lower display:

L.r.Oñ

Range:

ALG = The local setpoint will be

aligned to last remote setpoint value when transfer from remote
to local setpoint action is performed through external contact

n.ALG = The local setpoint will be

not be changed when transfer from remote to local setpoint
action is performed (The programmed ramp (Grd1/Grd2) may be
activated)

Available: When auxiliary input is used as remote set point
and (“A.I.Añ = norñ)
Note :If transfer from remote to local setpoint is due to auxiliary
input status(“A.I.Añ = Cnd.A) the local setpoint will never

will never

been

been aligned.