Super Systems AC20 User Manual

Page 38

Cnd.b = It starts in the same way it was left prior to

power shut down (if in manual mode the power
output will be equal to the last value prior to
power shut down).

NOTES

NOTES:
1) During the manual to auto transfer, the instrument maintains

the same power output as in manual mode.

2) Selecting the "buñ.b", the operative set point will be aligned

to the measured value.

3) The “alignment” is not performed if measure is in error

condition.

4) The selected local set point will be changed even if it is

software protected.

C.G06 -

Device status at start up

This parameter will be available only when at least one control
output is configured and manual function is enabled (“ñAn.F”
[C.G03] = “Enb”).
Upper display: CnF.4
Lower display: St.Fn
Range: Auto = It starts always in auto mode

ñan

= It starts always in manual mode with power

output set to 0

Cnd.A = It starts in the same way it was left prior to

power shut down (if in manual mode the power
output is set to 0)