Super Systems AC20 User Manual

Page 35

[r.E03] parameters.

- "Main control output max rate of rise" (see [r.E04]).
- "Control output display value" - for more details see "Display

function" paragraph at pag. 43 and [C.F02], [C.F03], [C.F04],
[C.F05] parameters.

- The control output value displayed by bargraph.

C.F07 - Secondary control output conditioning

C.F07 - Secondary control output conditioning
This parameter is available only when secondary control output is
configured.
Upper display: CnF.3
Lower display: SC.Cn
Range: norñ = The control output is as calculated by the PID.

CñPL = The control output is complemented (100-PID

calculated value).

C.F08 -

C.F08 - Secondary control output in engineering unit

Secondary control output in engineering unit

This parameter is available only when secondary control output is
configured.
Upper display: CnF.3
Lower display: S.SCL
Range: nO

= Scalable is not required

YES

= Scalable is required

NOTE

NOTE: This scaling allows to display the output value in
engineering units instead of in percent.

C.F09 -

C.F09 -Secondary control output decimal point

Secondary control output decimal point

position

position
This parameter is available only when "S.SCL" ("Secondary
control output in engineering units" [C.F08]) is set to "YES".
Upper display: CnF.3
Lower display: SC.dP
Range: ---.

= No decimal figure

--.-

= One decimal figure

-.--

= Two decimal figures

C.F10 -

C.F10 -Secondary control output initial scale value

Secondary control output initial scale value

This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F08]) is set to "YES".
Upper display: CnF.3
Lower display: SC.E.L
Range: from -199 to 999

C.F11 -

C.F11 -Secondary control output full scale value

Secondary control output full scale value

This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F08]) is set to "YES".
Upper display: CnF.3
Lower display: SC.E.H
Range: From -199 to 999