Super Systems AC20 User Manual

Page 45

CONFIGURATION GROUP END [C.Mxx]

CONFIGURATION GROUP END [C.Mxx]
END CONFIGURATION
This group is displayed only when configuration modify mode is
enabled.
Upper display: ConF
Lower display: End
Range: nO

= with this selection the instrument comes back

to the first display of the configuration modify
mode.

YES

= this selection ends the configuration modify

mode; the instrument preforms an automatic
reset and restarts in the run time mode.

Pushing ” ” or “ ” push-button select the desired action and then
push “MENU” push-button.

RUN TIME MODE

RUN TIME MODE
If V101 is correctly set (see "Operative mode and hardware lock"
at page 16), and the configuration mode has been terminated,
the instrument will be in run time mode and in "normal display
mode" (see below).
During run time mode the instrument performs the loop control
and manages all the instrument functions (SMART, ALARMS,
etc.).

DISPLAY FUNCTION

DISPLAY FUNCTION
When device is powered and it is operating in automatic mode,
the upper display shows the process variable, the middle display
shows the set point value (final or operative according to “SP.dS”
[C.I06] parameter setting).
We define the above condition as “normal display mode”.

The lower display will show:
a) the control output value.

NOTES:

NOTES:
1) If the instrument is configured with one control output

(linear or time proportional), the control output value is
displayed in the 0 to 100% range.