Super Systems AC20 User Manual

Page 47

NOTES:

NOTES:
1) The CO. value will be set to 20 if the auxiliary input is out

of range.

2) This indication is available only if the auxiliary input is

configured as CO input.

n)Pushing FUNC push-button again, the display will show "ñ.",

followed by the MAIN control output value with a range scaled
as configured by "CnF.3 - ñ.C.EL" [C.F04] and

"CnF.3 -

ñ.C.EH" [C.F05] parameters.
NOTE:

NOTE:

NOTE: this selection is available only if a scaled MAIN output
is selected.

o)Pushing FUNC push-button again, the display will show "S.",

followed by the SECONDARY control output value with a range
scaled as configured by "CnF.3 - S.C.EL" [C.F10] and
"CnF.3 - S.C.EH" [C.F11] parameters.
NOTE:

NOTE:

NOTE: this selection is available only if two outputs are set
and a scaled SECONDARY control output is configured.

Pushing FUNC push-button again, the control output value is
displayed.

All the visualization types described (exception made for "mV" and
"TP") are bound by time out (see “t.out” [C.I08] parameter), at the
end of the time out the display will return to show the control
output value.

NOTES

NOTES:
1) The previous information will be displayed only if the relative

function has previously been configured.

2) After parameter modification or monitoring, the instrument

comes back to the "normal display mode" with, on the lower
display, the indication previously selected.

INDICATORS

Two green LEDs located on the left of the middle display;
CP Lit when the carbon potential is the controlled variable.
DP Lit when the dew point is the controlled variable.

Two red LEDs located on the left of the lower display;
mV Lit when the sensor output (in mV) is the controlled

variable.

MAN Lit when device is in manual mode.