Super Systems AC20 - Manual (Page 97)

A. 1
DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS DEFAULT PARAMETERS
DEFAULT RUN TIME PARAMETERS DEFAULT RUN TIME PARAMETERS DEFAULT RUN TIME PARAMETERS DEFAULT RUN TIME PARAMETERS DEFAULT RUN TIME PARAMETERS
A complete and consistent set of run time parameters is stored
in the instrument. These data are the typical values loaded in
the instrument prior to shipment from factory.
This instrument allows you to load the default value of a single
run time parameter group or to load all the run time parameters
A ) When it is desired to load the default parameter of a single
group, proceed as follows:
A.1) By MENU pushbutton, select the desired run time
parameter group.
NOTE: NOTE: NOTE: NOTE: NOTE: if the selected group is protected by security
code, set the assigned value by V and W pushbuttons.
A.2) By FUNC pushbutton, select the last parameter of the
selected group.
The middle and lower displays will show:
A.3) By V or W pushbuttons, select the "On" indication on
the central display.
A.4) Push the FUNC pushbutton.
The default parameter loading procedure for the selected group
is ended.
B) When it is desired to load the default value of all the run
time parameters proceed as follows:
B.1) By MENU pushbutton, select the "Run time group dF"
[R.Lxx].
NOTE: NOTE: NOTE: NOTE: NOTE: if all run time parameters are protected by security
code, set the assigned value by V and W pushbuttons.
B.2) Push the FUNC pushbutton.
The middle and lower displays will show:
B.3) By V or W pushbuttons, select the "On" indication on
the central display.
B.4) Push the FUNC pushbutton.
The central display will show:
The default parameter loading procedure of all run time
parameters is ended.
ac20-ssi-A.pmd 19/12/2003, 9.11 1