Installation and setup – Measurement Computing LogBook Series User Manual
Page 91
LogBook User’s Manual
958396
GPS and Serial Device Data Collection 6-3
Installation and Setup
Installing a New System
For new LogBook systems, perform the following steps to install.
Step 1
Follow the general instructions included with your
LogBook for installing your hardware and software.
Step 2 Launch
LogView.
Step 3 Select
File/Authorization…
Step 4 Enter
ED7B55484273
, then click Apply Code.
Step 5
Connect your serial device(s).
Step 6
Close and re-launch LogView.
Upgrading an Older System
When adding the GPS/Serial Input option as an upgrade to an older
LogBook system, perform the following steps:
Step 1 Use
the
Add/Remove Programs utility in the Windows
Control Panel to uninstall your current version of LogView.
Step 2
Insert the upgrade CD. If Autorun is enabled, the setup
program will launch automatically. If it’s disabled, run
SETUP.EXE from the root directory of the CD.
Step 3
In the opening window, select LogBook support and click
OK.
Step 4
Follow the on-screen instructions to complete the installation.
Note:
It may be necessary to restart your computer when the setup
program is complete.
Step 5
After restarting your computer, launch LogView.
Step 6
Select File/Authorization…
Step 7 Enter
ED7B55484273
, then click Apply Code.
Step 8
Connect your serial device(s).
Step 9
Close and re-launch LogView.