Measurement Computing LogBook Series - Manual (Page 193)

LogBook User’s Manual, Appendix A 887997 Supplement / HopNet Modems A-9
Setting a Modem for Remote Operation
HopNet Modems have a factory default setting for being “Remote” units. You can ensure that the unit is
set for “Remote” by entering the following commands. In order to enter these commands, successful
completion of steps listed in the section,
Getting Started with WinCOM24, is required.
To ensure that a modem is set for “Remote” operation, enter the commands and reset the baud rate in this
order :
1. Type: sp00 press This sets the protocol mode to “point-to-point” transparent mode.
2. Type: wb0 press This sets the modem unit for “Remote” operation. This is the default setting.
3. Type: zb0 press Disables the Banner Display.
4. Type: m> press This is the “Save” command.
5. Type: sd01 press Sets the Baud Rate to 115200.
6. In the Baud Rate Box (lower right of screen), change the baud rate to 115200,
as indicated in the previous figure.
7. Type: m> press This is the “Save” command.
Frequently Asked Questions
Q: I’ve tried to attach the Logbook after configuring the Serial Port Fixed Baud Rate Setup for the device:
LogBook Serial Fixed. It did not connect. What should I do?
A: Try the following:
(a) Turn OFF the LogBook, then restart it to initialize the configuration.
(b) Verify that the proper RS232 cable is connected.
(c) Verify that the configuration in the LogBook Control Panel Applet matches that of the
configuration downloaded to the LogBook.
(d) Verify that the Serial Ports (on both the LogBook and on the PC) work.
Q: I’ve tried to attach the Logbook after configuring the Serial Port Fixed Baud Rate Setup for the device:
LogBook HopNet. It did not connect. What should I do?
A: Try the following:
(a) Turn OFF the LogBook, then restart it to initialize the configuration.
(b) Verify that the proper 9-pin cable is connected to the LogBook from the HopNet Modem.
(c) Verify that the proper 9-pin cable is connected to the PC from the HopNet Modem.
(d) Verify that the HopNet Modem is connected to the intended hardware, e.g. LogBook/PC,
remote/receiver.
(e) Verify that the configuration in the LogBook Control Panel Applet matches that of the
configuration downloaded to the LogBook.
(f) Verify that the Serial Ports (on both the LogBook and on the PC) work.