Measurement Computing LogBook Series - Manual (Page 35)

QS360- 2
LogBook/360 Quick Start Guide
Reference Notes:
Depending on the nature of your LogBook system, you may find one or more of the following references to the
LogBook User’s Manual PDF helpful. The PDF manual is included on the Data Acquisition CD and is also
available on our web-site.
o For block diagrams and operational overviews, refer to Chapter 1 of the LogBook User’s Manual PDF.
o For system expansion and calculating system power, refer to Ch. 4 and to the DBK Basics section.
o For information regarding LBK options, refer to Chapter 5.
o For specific DBK card information, refer to the DBK Options Manual PDF.
Note: The LogBook/360 rear panel supports three termination panels. Many different combinations are
possible.
WARNING
Electric shock hazard. Turn off power to all system-connected devices prior to connecting or
disconnecting cables, or setting hardware configurations. Failure to do so could result in electric shock
or death, and equipment damage, even under low-voltage conditions.
CAUTION
Use ESD tools, containers, and procedures during setup of DBK cards. Electrostatic
discharge can damage some components. To prevent pin damage, align DBK cards with the
backplane DB37 connectors, then gently press them together.
When using LogBook in attached mode, the PC-Card [in LogBook] must already have the file
logbook.sys.
Otherwise, LogView cannot communicate with LogBook, and LogBook will
appear dead.