Nu…… lv-29, Re configuration…… lv-29, View menu – Measurement Computing LogBook Series User Manual
Page 155: Hardware configuration
Software Reference
989592
LogView LV-29
View Menu
Hardware Configuration
Analog Input Channels
Digital Input Channels
Output Channels
GPS/Serial Input Channels
Calculated Channels
Acquisition Configuration
Preferences
The View menu includes configuration windows, most of them in the spreadsheet format.
Descriptions of the View pull-down menu’s selections follow.
Hardware
Configuration
Selecting Hardware Configuration brings up the windows shown below. As you progress
through the hardware tree, the window will prompt you for related information as needed. All 3
I/O ports (P1, P2, P3) are set up here.
Note: these windows only set up non-programmable parameters to match corresponding hardware
settings. LogView cannot know these settings unless you enter them here. Some DBKs have
programmable settings that must be set under the DBK Parameters tab of the Analog Input
Channel Configuration window.
This figure shows user
selecting the differential
mode of analog input on
P1.
This figure shows user
selecting a particular DBK
to be attached to channel
15 of P1.