Gasboy Atlas Fuel Systems Owner Manual - Manual (Page 71)

MDE-4363F Atlas™ Fuel Systems Owner’s Manual · September 2011 Page 67
Preventive Maintenance The Atlas Fuel System
Pump pulleys, belts, and
belt tension Every six months
or if a squealing
noise occurs
during unit
operation 1 Remove power to the unit. • Owner—Inspect
• ASC only—Repair
and test
2 Inspect belts for fraying/cracks.
3 Inspect pulleys for excessive wear in grooves and
excessive bearing play.
Tank Every six months 1 Monitor water levels in tank with electronic tank monitor or
water detection pasted on tank measuring stick. Owner - Inspect
2 If repair is required, call an ASC.
Components
Recommended
Frequency
Recommended Maintenance
Who Performs the
Inspection/Repair
WARNING
Self-contained pumps have a pinch point between the belts and the pulleys.
Severe injury could occur if part of the body is pulled into the pinch point.
To prevent injury when inspecting self-contained units, do not place your
hands near the belts, pulleys, or motors. Turn off the power before servicing
the unit. Do not operate the unit with the door removed.
CAUT
WARNING
Failure to remove power to the unit before servicing it could result in injury.
Failure to remove power could create a hazard, such as electrical shock.
Remove power to the unit before servicing it.
WARNING
The pump/dispenser contains pressurized flammable fuel and lethal
voltages.
Servicing a Gasboy unit incorrectly could result in severe injury or death.
Do not attempt to service Gasboy pump/dispenser yourself and do not
allow untrained personnel to service Gasboy pumps/dispensers. Only
Gasboy-trained ASCs must service a Gasboy unit.