Filter strainer replacement, Warning – Gasboy Atlas Fuel Systems Owner Manual User Manual
Page 62
The Atlas Fuel System
Preventive Maintenance
Page 58
MDE-4363F Atlas™ Fuel Systems Owner’s Manual · September 2011
5
Move the reset lever to the OFF position, and then back to the ON position to verify if the reset
motor operates properly. The reset coupling must make one revolution and stop.
Figure 3-31: Power Reset for Pump or Remote Dispenser Unit
Filter Strainer Replacement
If the unit is equipped with a strainer and filter, inspect and change it at regular intervals
(refer to
“Filter change and strainer cleaning”
“Preventive Maintenance Table”
A dirty strainer or filter in a pump or remote dispenser causes a slower delivery rate. Refer to
the accessories section of your parts manual to ensure that you replace the strainer if required
and filter with one designed for your model. Always use a drip pan and absorbent material
directly below the filter when removing the cartridge to prevent contamination of both the soil
and the electrical components within the cabinet. This service must not be done by untrained
individuals.
Adjustment Screw
Lock Nut
High alcohol percentage fuels such as E85 or fluids such as DEF may be incompatible
with certain plumbing materials and hydraulic components.
Use of incompatible materials or components with E85 can result in leaks. For E85,
unexpected failures of components may also occur resulting in fire or explosion or
environmental damage. When installing components in E85 units, refer to
on
When dispensing alternative fuels such as E85 or fluids such as DEF, verify with the
manufacturer if the material of all plumbing components are compatible with the fuel
(E85) or fluid being dispensed.
WARNING