Gasboy Atlas Fuel Systems Owner Manual - Manual (Page 35)

MDE-4363F Atlas™ Fuel Systems Owner’s Manual · September 2011 Page 31
Programming 8800 Models The Atlas Fuel System
Programming 8800 Models
General Programming
Programming the unit is divided into three levels; Level 1, 2, and 3. Level 1 codes are
explained here. The default code for level 1 is 2222. This code can be changed for station
security, however losing the codes will require a master reset of the unit. Reprogramming
codes found in Level 1 are shown below:
• CC 1 Manual programming of PPU (unit pricing). Pricing can also be downloaded
through the Two-wire communication using the Point Of Sale (POS) device.
• CC 2 Sitting mode of operation as being stand alone (isolates sale control from the POS)
or Two-wire (unit control through the POS).
• CC 3 Programming Volume Allocation. This basically sets the maximum sale size in units
of measure (gallons for example).
• CC 4 Manual Blank and Five-Button Preset. This dual use code allows turning the
displays off manually or is used to activate different preset modes depending on the
options included with the unit.
• CC 5 Test Programmable Customer Preset. This code is used to initiate testing for the 5
Button Preset option, if used.
• CC 6 Memory Clear. This code is useful only to clear a unit displaying an Error Code (EC)
31 Totals Data Error) or EC 35 Configuration Data Error.
• CC 7 Setting Totals Input. This code allows setting of non zero totals. It is useful for new
installs or service (old dispensers are replaced or receive certain types of service), when
the station does not want to restart totals for its dispensers at zero. It can only be
performed after performing a master reset, CC7, or for new units.
• CC 8 display Pump Controller Firmware Version.