Maintenance of vendor supplied parts, Performing inspections, Caution – Gasboy Atlas Fuel Systems Owner Manual User Manual
Page 59: Warning
MDE-4363F Atlas™ Fuel Systems Owner’s Manual · September 2011
Page 55
Preventive Maintenance
The Atlas Fuel System
Maintenance of Vendor Supplied Parts
Certain parts of the dispenser/pump are produced by vendors for Gasboy (hoses, nozzles, and
so on) and as such may have documentation separate from that which Gasboy supplies. In such
cases, it is required to consult the vendor documentation for service intervals and any
adjustments that is required for your dispenser/pump.
Use Authorized Parts
The use of unauthorized parts can:
• Void your warranty.
• Cause the loss of continuity of the Underwriters Label on the pump.
• Cause inefficient operation.
• Possibly cause an operational hazard.
Always use new gaskets and seals when servicing or rebuilding Gasboy equipment.
Performing Inspections
This section provides instructions for scheduling two types of maintenance inspections:
• General inspections
• Component inspections
Moisture from rain can damage the internal components of a pump/dispenser.
Internal components that are exposed to moisture may not operate correctly.
Do not open the electronics cabinet to perform any other tasks when it is raining.
CAUTION
High alcohol percentage fuels such as E85 or fluids such as DEF may be incompatible
with certain plumbing materials and hydraulic components.
Use of incompatible materials or components with E85 can result in leaks. For E85,
unexpected failures of components may also occur resulting in fire or explosion or
environmental damage. When installing components in E85 units, refer to
on
.
When dispensing alternative fuels such as E85 or fluids such as DEF, verify with the
manufacturer if the material of all plumbing components are compatible with the fuel
(E85) or fluid being dispensed.
WARNING