Comtech EF Data LBC-4000 - Manual (Page 98)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Ethernet-based Remote Product Management MN-LBC4000A
6–22
Next Reboot Image
Use the drop‐down menu to select Image 1 or 2. Press [Submit] when done.
Click [Reboot Now] to reboot the LBC‐4000 using the Current Active Firmware Image.
Fault Relay Logic
Use the drop‐down menu to select the Fault Relay Logic as Normal or Invert, and then click
[Submit].
Perform Soft Reboot
Click [Reboot Now] to reboot the LBC‐4000 using the Current Active Firmware Image.
Firmware Information (read-only)
This scrollable window identifies the Bootrom, Bulk Image#1 and Bulk Image #2 firmware
information.
To update the page with the latest available parameters, click [Refresh].
6.4.5.3.4 Config | Redundancy
Appendix B. LBC-4000 REDUNDANCY OPERATION.
Use this page to configure the LBC‐4000’s Redundancy Switch Mode.
Figure 6-9. Config | Redundancy page