Comtech EF Data LBC-4000 - Manual (Page 100)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Ethernet-based Remote Product Management MN-LBC4000A
6–24
6.4.5.4 Status Pages
The hyperlinks available under the ‘Status’ tab provide access to operational statistics, status
windows, and a logged fault table.
Click the Summary or Faults hyperlink to continue.
6.4.5.4.1 Status | Summary
Use this read‐only page to review pertinent information about the configured setup of the
LBC‐4000, its current operating parameters, and the operational status of the unit.
Figure 6-11. Status | Summary page
Typical for all sections, when operating parameters are within acceptable limits for any item, the
STATUS indicates OK within a green box. If a fault condition exists, the message box changes to
red with the FAULT indicated accordingly.
Parameter Status section
Product identification (i.e., CID, serial and model numbers), active firmware, software image
information, and other operational configuration information is provided here.