Comtech EF Data LBC-4000 - Manual (Page 115)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Serial-based Remote Product Management MN-LBC4000A
7–13
Parameter
Type
Command
(Instruction Code
and
Qualifier)
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes between
48 and 57)
Response to Command
(Target to controller)
Query
(Instruction Code
and qualifier)
Response to query
(Target to controller)
Retrieve Firmware
Number N/A Query only.
Gets the Firmware Numbers of the unit.
Example: FRW_
BULK=FW/9965X
M&C =FW/9966X
FPGA=FW/9967X
(Where ‘X’ denotes the firmware revision letter)
N/A FRW_ FRW_
(see Description of
Arguments for details)
List all alarms N/A variable Query only.
This command retrieves a list of the stored alarms.
List All Alarms: LAA_’cr’
Confirmation: LAA_’cr’
xx yyyyyyyyyyy hh:mm:ss mm/dd/yy’cr’
xx yyyyyyyyyyy hh:mm:ss mm/dd/yy’cr’
xx yyyyyyyyyyy hh:mm:ss mm/dd/yy’cr’
“
“ “ “
“ “ “ “
xx yyyyyyyyyyy hh:mm:ss mm/dd/yy’cr’’lf’]
Where:
xx = stored fault number.
Yyyyyyyyyyy = fault description.
Hh:mm:ss = fault time.
Mm/dd/yy = fault date.
N/A LAA_ LLA_
xx y..y h..s m..y
(see Description of
Arguments for details)
Mute State MUT_ 5 bytes,
alpha
Command or Query.
Mutes/Unmutes the converter in the form MUT_x_yyy
where:
x = ‘A’ (Converter A) or ‘B’ (Converter B)
yyy = ON (mute) or OFF (unmute)
Example: MUT_A_OFF (Unmutes Converter A)
Same as command MUT_x_ MUT_x_yyy
(see Description of
Arguments for details)
Online Unit
Status
N/A 1 byte
alphanumeric
Query only.
Indicates which slot is online in the form ONL_x where:
x = A or B (depending on which Converter is online).
N/A ONL_ ONL_
(see Description of
Arguments for details)
Retrieve
Alarm Status N/A 122 bytes
alphanumeric
Query only.
Used to Query the Alarm status of the unit, where: xx = OK (no
fault) or FT (fault): N/A RAS_
RAS_
x….x