Comtech EF Data LBC-4000 - Manual (Page 123)

A–1
Appendix A. UP/DOWNCONVERTER IDU
MODULE REMOVAL/RE-INSTALLATION
A.1 Introduction
This appendix illustrates the procedure required to remove and
re‐install an IDU for the LBC‐4000 Up/Down Converter System
with Ethernet into any LBC‐4000 chassis (Figure A‐1, showing a
serial‐only, non‐Ethernet base unit with the top cover removed
for clarity). This procedure is typical for removing or installing
an IDU into the LBC‐4000’s applicable Conv A or Conv B bay.
Although Figure A‐1 shows the chassis for the
LBC‐4000 L‐Band Up/Down Converter System
without Ethernet, the procedures in this appendix
are identical for the Ethernet‐based LBC‐4000.
Figure A-1. LBC-4000 Chassis – IDU Module Bays