Comtech EF Data LBC-4000 - Manual (Page 97)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Ethernet-based Remote Product Management MN-LBC4000A
6–21
6.4.5.3.3 Config | Utility
Use this page to configure LBC‐4000 operating parameters.
Figure 6-8. Config | Utility page
Date
Enter a date in the form MM/DD/YY (where MM = month [01 to 12], DD = day [01 to 31], and YY
= year [00 to 99]).
Time
Enter a time in the form HH:MM:SS (where HH = hour [00 to 23], MM = minutes [00 to 59], and
SS = seconds [00 to 59]).
Click [Change Date/Time] to save these changes.
Circuit ID
Enter a Circuit ID string of up to 48 characters, and then click [Change CID] to save this change.
Current Active Firmware Image (read-only)
This section identifies the selected Current Active Firmware Image. In this example, Image 1 is
the Current Active Firmware Image.