Comtech EF Data LBC-4000 - Manual (Page 62)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Front Panel Operation MN-LBC4000A
5–6
Each menu branch available from the top‐level (main) menu, the functional description of each
branch, and its content section in this chapter, is identified as follows:
Menu Branch Sect Description
CONFIG 5.2.1 (Configuration) Use to fully configure the LBC-4000A.
MONITOR 5.2.2
Use to monitor the alarm status of the unit, view the log of stored events, and
display the Receive Parameters screen.
FAULTS 5.2.3
Use to view information on the unit, without having to access configuration
screens.
UTILITY 5.2.4
(Utility) Use to perform miscellaneous functions, such as setting the Real-time
clock, adjusting the display brightness, etc.
Use the [←][→] arrow keys to select from the choices shown, and then press [ENT].
5.2.1 CONFIG (CONFIGURATION)
CONV-A CONV-B REMOTE
REDUND REFADJ SPECT-INV
Use the [←][→] arrow keys to select from the submenu choices shown, and then press [ENT].
Each submenu available from the Configuration menu branch – typical for Converter A or
Converter B – its content section in this chapter, and the functional description of each submenu
is identified as follows:
Submenu Sect Description
CONV-A
CONV-B
5.2.1.1
(Converter Unit A or B) Displays the current configuration of the selected
converter, including the frequency, attenuation, and slope.
REMOTE 5.2.1.2
(Remote Control) Defines whether the unit is being controlled locally or
remotely, and identifies the unit address, interface type, and rate and format of
the baud parameters.
REDUND 5.2.1.3
(Redundancy – overview only) Identifies the redundancy state and mode
(refer to Appendix B. LBC-4000 REDUNDANCY OPERATION for detailed
information).
REFADJ 5.2.1.4 (Reference Oscillator Adjustment) Adjusts the reference oscillator.
SPECT-INV 5.2.1.5 (Spectrum Inversion)