Comtech EF Data LBC-4000 - Manual (Page 135)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Appendix B MN-LBC4000A
B–5
B.3.2 CONFIG (Configuration) Menu
CONV-A CONV-B REMOTE
REDUND REFADJ SPECT-INV
Use the [←][→] arrow keys to select from the submenu choices shown, and then press [ENT].
Each submenu available from the Configuration menu branch is typical for Converter A or
Converter B.
For quick reference, a description of each of the submenu branches follows, and the section in
this appendix (as shown in bold) that addresses use relevant to Redundancy operation.
Otherwise, see Chapter 5. FRONT PANEL OPERATION for complete information on the
functionality of these features:
Submenu Ch. 5 / App. B Sect Description
CONV-A
CONV-B 5.2.1.1
B.3.4
(Converter Unit A or B) Displays the current configuration
of the selected converter, including the frequency,
attenuation, and slope.
REMOTE 5.2.1.2
(Remote Control) Defines whether the unit is being controlled
locally or remotely, and identifies the unit address, interface
type, and rate and format of the baud parameters.
REDUND
5.2.1.3
B.3.3
(Redundancy) Identifies the redundancy state and mode
REFADJ 5.2.1.4
(Reference Oscillator Adjustment) Adjusts the reference
oscillator.
SPECT-INV 5.2.1.5 (Spectrum Inversion)