Comtech EF Data LBC-4000 - Manual (Page 138)

LBC-4000 L-Band Up/Down Converter System with Ethernet Revision 2
Appendix B MN-LBC4000A
B–8
B.4 Redundancy Operations via the LBC-4000 Web Server Interface
Chapter 6. ETHERNET‐BASED REMOTE PRODUCT MANAGEMENT
Use the LBC‐4000 Web Server Interface ‘Config | Redundancy’ page to configure the LBC‐4000’s
Redundancy Switch Mode.
Figure B-4. Config | Redundancy page
Redundancy State
Use the drop‐down menu to Enable or Disable LBC‐4000 Redundancy, and then click [Change] to
set LBC‐4000 Redundancy operation to this select status.
Redundancy Mode
Use the drop‐down menu to select Redundancy Mode operation as Manual or Auto, and then
click [Change] to update LBC‐4000 Redundancy operation to this select operating mode.
Force Backup
Use the drop‐down menu to select Yes, and then click [Change] to force the redundant unit into
standby mode.
The last section on this page displays the read‐only Online or Offline status for each converter.
To update the page with its latest operating parameters, click [Refresh].