Comtech EF Data SFC1800A - Manual (Page 58)

User Interfaces SFC1800A Synthesized Frequency Upconverter
4-34 TM111 - Rev. 1.0
4.6.2.4 Logging On
1.
The user must be logged on to have access to SNMP Features. To log on the SNMP
configuration, press ‘50’ followed by to open the Logon Dialog Box.
+ - - - - - - - - - - - - - - - - - - | Logon | - - - - - - - - - - - - - - - - - - - - - -+
| |
| 1.User ID : |
| 2.Password : |
| 3.OK 4.CANCEL |
| |
+ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - +
2.
In the User ID Text Box, enter “Oper-md5” (case sensitive).
3.
In the Password Text Box, enter “Oper” (case sensitive).
4.
Select OK
4.6.2.5 Changing the Logon Password
To change the password, logged on so that the “SNMP/Security” selection appears. Press ‘54’
followed by to open the Change Logon Password dialog.
+ - - - - - - - - - - - - - | Change Password | - - - - - - - - - - - - - - - - - -+
| |
| 1.Old Password: |
| 2.New Password: |
| 3.Re-enter New Password: |
| 4.OK 5.CANCEL |
| |
+ - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - +
1.
In the Old Password Text Box, enter “Oper” (case sensitive).
2.
In the New Password Text Box, enter the new password (case sensitive, only *’s appear
for security).
3.
Re-enter the new password to verify the desired setting.
4.
Select OK
4.6.2.6 Logging Off
1.
To log off the SNMP Configuration, press ‘51’ followed by . The following
confirmation message will be displayed to avoid inadvertent exits:
You will be logged off. Are you sure? (Y/N):