Comtech EF Data SFC1800A - Manual (Page 118)

Appendix C SFC1800A Synthesized Frequency Upconverter
C-8 TM111 – Rev. 1.0
For Upconverter:
cc = channel (01 to 30)
gg.g = gain (-20.0 to +30.0) depending on Input Attenuation
ffff = frequency MHz (ffff.0 to ffff.0)
{ffff.0 = frequency in MHz, low end to high end}
t = Kilohertz step ( 0 to 7 for 000 - 875 in 125 kHz increments)
{End of transmission}
A backup converter in a 1:8 Switch Configuration will return the following string of information:
abcdefgh = Priority settings for converters 1 - 8 respectively
0 = None. Backup will ignore converter
1 = Highest priority
8 = Lowest Priority
n = Used with manual backup command MANBACK as follows:
0 = Places the Backup in Standby mode, all Primes
online
1 - 8 Specifies the Prime to be taken offline and replaced
by the Backup
{End of transmission}
A backup converter in a 1:1 Switch Configuration will return the following string of information:
There are no data specific commands for the backup converter in the one for one switch
configuration
{End of transmission}
C.4 Show Received Signal Strength Command (Upconverter Only)(S, P1:1,
P1:8)
This command will cause the converter to output the Received Signal Strength.
@01/SHOWRSS
The converter will return the following:
RSS: vv
{vv = value for Received Signal Strength}
{End of transmission}