Comtech EF Data SFC1800A - Manual (Page 129)

SFC1800A Synthesized Frequency Upconverter Appendix B
TM111 – Rev. 1.0 B- 19
Performance specifications guaranteed at nominal levels only.
Note: Parameters are not actual values for frequency and attenuation but the actual index into
the various arrays that make up the power calibration table: The valid ranges for these values are
dependant on device type and configuration.
If successful, the converter will not return a string.
C.24 Get Gain Offset (Upconverter Only)
This command displays the value for the Gain Offset. The command is as follows:
@01/GAINOFFSET?
If successful, the converter will return the following string:
Gain Offset Value = gg:
{gg is the gain offset value}
{End of transmission}
C.25 Set Gain Offset (Upconverter Only)
This command sets the value for the Gain Offset. The command is as follows:
@01/GAINOFFSET =
If successful, the converter will return the following string:
Gain Offset Value = gg:
{gg is the gain offset value}
{End of transmission}
C.26 Dump Channel Table (All)
This command returns the contents of the Channel Table. The command is as follows:
@01/DMPCHAN
If successful, the converter will return the following string:
[ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g]
[ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g]
[ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g]