Comtech EF Data SFC1800A User Manual
Page 36
User Interfaces
SFC1800A Synthesized Frequency Upconverter
4-12
TM111 - Rev. 1.0
CPLD VERSION:
{x.x}
Displays version number of installed CPLD Firmware.
FPGA VERSION:
{x.x}
Displays version number of installed FPGA firmware.
HARDWARE:
CONVRTR CONFIG:
{STAND ALONE, PRIMARY 1F1, BACKUP 1F1,
PRIMARY 1 - 8 1F8, BACKUP 1F8}
Allows the user to indicate the function of the Converter
as it is connected in the system. The M&C determines
this by reading 4 ID bits through the switch interface
(refer to Section 5.10).
CONVERTER ID:
{1 - 11, 15}
Displays a decimal version of the binary ID bits
described above and in Section 5.10. The individual bits
are strapped high or low at the switch. They are
decoded as follows.
Decimal ID
Converter Function
System Type
0
Not Used
Not Used
1
Primary 1
1F8
2
Primary 2
1F8
3
Primary 3
1F8
4
Primary 4
1F8
5
Primary 5
1F8
6
Primary 6
1F8
7
Primary 7
1F8
8
Primary 8
1F8
9
Backup
1F8
10
Backup
1F1
11
Primary
1F1
12 – 14
Not Used
Not Used
15
Stand Alone (ID Bits
pulled up on
Controller Card)
Stand Alone
CONVERTER TYPE:
{DN CONVERTER, UPCONVERTER}
Indicates whether the unit is an Upconverter or a
Upconverter. This display will match the text on the
Front Panel Overlay.