Comtech EF Data SFC1800A - Manual (Page 11)

SFC1800A Synthesized Frequency Upconverter Table of Contents
TM111 – Rev. 1.0 xi
Appendix A - Remote Operations
A.1 SFC1800A Upconverter Opcode Command Set _________________________ A-1
A.2 Converter Queries ________________________________________________ A-2
A.3 Switch Queries ___________________________________________________ A-5
A.4 Converter Commands______________________________________________ A-7
A.5 Switch Commands ________________________________________________ A-8
Appendix B - SNMP MIB ______________________________________________ B-1
Appendix C - Remote ASCII
C.0 Control Commands________________________________________________ C-1
C.1 Remote Help Menu (All) ____________________________________________ C-2
C.2 Status Command (All) _____________________________________________ C-5
C.3 Data (All)________________________________________________________ C-7
C.4 Show Received Signal Strength Command (Upconverter Only)(S, P1:1, P1:8) _ C-8
C.5 Show Priority Command (B1: 8) ______________________________________ C-9
C.6 Set Current Channel Frequency Command (S, P1:1, P1:8) _________________ C-9
C.7 Set Current Channel Gain Command (S, P1:1, P1:8) ____________________ C-10
C.8 Set Channel Command (S, P1:1, P1:8) _______________________________ C-11
C.9 Set Priority (B1: 8) _______________________________________________ C-12
C.10 Store Current Channel Settings (S, P1: 1, P1: 8) _______________________ C-12
C.11 RF On/Off Command (Upconverter Only) (All) _________________________ C-13
C.12 Change Input Attenuation Command (Upconverter Only)(S, P1: 1, P1: 8) ___ C-13
C.13 Clear Faults Command (All) _______________________________________ C-14
C.14 Auto Mode Command (P1: 1, B1: 1, B1: 8) ___________________________ C-14
C.15 Manual Mode Command (P1: 1, B1: 1) ______________________________ C-14
C.16 Manual Backup Command (B1: 8) __________________________________ C-15
C.17 Set Stored Gain For a Specified Channel (S, P1: 1, P1: 8) _______________ C-16
C.18 Set Stored Frequency For a Specified Channel (S, P1: 1, P1: 8) __________ C-16
C.19 Erase (All) _____________________________________________________ C-16
C.20 Restart (All)____________________________________________________ C-16
C.21 Learn (B1: 1, B1: 8) _____________________________________________ C-16
C.22 Read DAC Value by Index (All) ____________________________________ C-18
C.23 Write DAC Value by Index (All) ____________________________________ C-18
C.24 Get Gain Offset (Upconverter Only) _________________________________ C-19