BrightSign Object Reference Manual (FW 5.1) - Manual (Page 283)

275
roIRReceiver
This object supports receiving arbitrary Infrared remote control codes using the NEC and RC5 protocols.
Object Creation: The roIRReceiver object is created with an associative array specifying the following:
• source: A string value indicating the source of the input.
o "IR-in": The 3.5mm IR input/output connector (available on 4Kx42 and XDx32 models)
o "GPIO": Pin 1 of the GPIO connector
o "Iguana": The
Iguanaworks IR transceiver. This source can support both NEC and RC5 encodings
simultaneously.
• encodings: An array indicating the required encodings.
o "NEC"
o "RC5" (supported on the Iguanaworks IR transceiver only)
CreateObject("roIRReceiver", config As roAssociativeArray)
NEC codes are expressed in 24 bits:
• Bits 0-7: Button code
• Bits 8-23: Manufacturer code
Note: If the manufacturer code is zero, then the code is considered to be intended for the Roku SoundBridge remote
control.
The roIRReceiver object can generate the following events:
• roIRDownEvent: Generates when a button is pressed.
• roIRRepeatEvent: Generates when a button repeats.
• roIRUpEvent (Iguanaworks IR transceiver only): Generates when a button is released.