Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 77)

Service Processor
ATCA-9405 Installation and Use (6806800M71G) 77
4.5.4 Variables for Controlling the Boot Progress
shelf_id The first byte of the shelf identifier as read from the shelf manager
shelf_location Two bytes encoding the logical slot number and the 1st byte of the shelf
ID, each octet separated by a colon
dhcp_clid The DHCP client ID (option 61) used in DHCP discover
uboot_version The U-Boot firmware version (in the format V..).
ethaddr
eth1addr
eth2addr The Ethernet MAC addresses for the local network interfaces
fpga_version Version of Glue Logic FPGA
Table 4-4 Dynamic Variables Set During the Boot Phase (continued)
Variable Name Description
Table 4-5 Variables for Controlling the Boot Progress
Variable Name Default Description
bmc_wd_timeout undefined Configures the IPMI watchdog time-out for booting
the OS in seconds. Setting it to -1 (default) disables
the IPMI watchdog.
ethdefault undefined The default network interface to be configured. If
set, the ethact variable is initially assiged to the
value of this parameter.
bootcmd run $ramboot A sequence of commands executed to boot the
operating system (via auto boot or the boot
command)
bootargs undefined Arguments for the operating system (that is, the
linux kernel command line or the vxWorks boot
parameters).
bootdelay 10 Delay in seconds before the automatic boot
sequence starts.
A value of "-1" disables autoboot
serverip undefined The IP address of the boot server