Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 15)

ATCA-9405 Installation and Use (6806800M71G) 15
About this Manual
Overview of Contents
This manual is divided into the following chapters and appendix:
 Chapter 1, Introduction, on page 21 , provides an overview of the ATCA-9405 board.
 Chapter 2, Setup, on page 31 , describes the ATCA-9405 board dimensions, power
requirements, environmental requirements, how to insert and remove the board,
troubleshooting and so on.
 Chapter 3, Packet Processor, on page 59 , provides an overview of the CN6880 Processor and
its units.
 Chapter 4, Service Processor, on page 71 , provides an overview of the P2020 Processor and
its units.
 Chapter 5, Ethernet Infrastructure, on page 89 , describes the ethernet switch, base
interface, fabric interface, update channel interface, and the serial redirection.
 Chapter 6, Service Infrastructure, on page 101 , describes the PCI express switch, hot plug
support, I2C slave interface, JTAG support, and lane status.
 Chapter 7, Mezzanine Module, on page 107 , provides an overview.
 Chapter 8, Intelligent Peripheral Management Controller, on page 111 , provides a functional
overview, firmware architecture, HPM.1 components, Sensors, and so on.
 Appendix A, Related Documentation, on page 155 , lists the documents that you can refer.
 Safety Notes on page 157 , provides the safety measures to be taken while handling the
board.
 Sicherheitshinweise on page 161 , provides the German translation of the Safety Notes.