Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 32)

Setup
ATCA-9405 Installation and Use (6806800M71G) 32
2.3 ATCA-9405 Circuit Board
The ATCA-9405 circuit board is an ATCA blade assembly and complies with the PICMG 3.0 ATCA
mechanical specification. It uses a 16-layer printed circuit board with the following dimensions:
The Figure 2-1 on page 32 , shows the face plate layout for ATCA-9405 board.
The face plate of the blade provides the following interfaces and control elements.
Table 2-1 Circuit Board Dimensions
Width Depth Height Weight (typical)
12.687 in.
(322.25 mm) 11.024 in.
(280.01 mm) < .84 in.
(<21.33 mm) 8.38 lb. (3.80 kg)
This is the typical weight for the ATCA-9405. Board weight varies slightly per configuration; contact
Technical Support if you require a specific configuration weight.
Figure 2-1 Faceplate Layout
Table 2-2 Faceplate Interfaces
Processor Interfaces / Control Elements
Packet Processor One Serial Console port for Packet Processor 1 (only for maintenance
purposes)
One Serial Console port for Packet Processor 2 (only for maintenance
purposes)
One 10/100/1000Base-T Ethernet port shared for both Packet
Processors (only for maintenance purposes)
Service Processor One USB port (only for maintenance purposes)
One Serial Console port (only for maintenance purposes)
One 10/100/1000Base-T Ethernet port (only for maintenance purposes)