Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 142)

Intelligent Peripheral Management Controller
ATCA-9405 Installation and Use (6806800M71G) 142
Due to the fact, that there is no authenticated IPMI communication to the IPMC, the channels
are implemented IPMI session-less. For TS channel properties, see
Table 8-11 on page 142 .
8.13.1 Evaluating the Version of the Telnet Server Firmware
The firmware version of the terminal server can be retrieved with the IPMI command Get SOL
Configuration,
executed with the OEM parameter 192.
ipmicmd -k "0 0 c 22 5 C0 0 0" smi 0
8.13.2 Establishing a Telnet Session
SOL client is not required to establish a serial connection to the ATCA-9405 payload serial line
via network Base Interface #1 or #2. The TS can be configured very easily via IPMI commands.
To establish a telnet session at OEM channel 5, follow the configuration steps executed from
the ShMM first (steps in bold are mandatory if IP address of TS is not default):
1. This step is not required if LAN parameters are not modified (step 2 to 4 is not executed).
To enable LAN configuration, the Set_In_Progress flag must be set:
ipmicmd -k "0 0 c 1 5 0 1" smi 0
2. This step is not required if the IPMC default is used: default IP address 172.17.0.220.
To set the IP address, execute the following command:
ipmicmd -k "0 0 c 1 5 3 " smi 0
for example, if the IP addresss is 192.168.1.100, then the command is:
ipmicmd -k "0 0 c 1 5 3 c0 a8 01 64" smi 0
Table 8-11 TS Channel Information
Channel Protocol Type OEM Protocol 0x1C
Channel Medium Type OEM 0x60
Session support Session-less 0x00
Vendor ID ARTESYN IANA 0xCD 0x65 0x00
Auxiliary Channel Info