Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 120)

Intelligent Peripheral Management Controller
ATCA-9405 Installation and Use (6806800M71G) 120
BANK : J - Operational
Firmware Name : PYLD FPGA
Firmware Version : 0.40.0000000F
BANK : K - Rollback
Firmware Name : PYLD FPGA
Firmware Version : 0.120.00000010
BANK : M - Operational
Firmware Name : PYLD F/W
Firmware Version : 1.0.00000001
BANK : N - Rollback
Firmware Name : PYLD F/W
Firmware Version : 1.0.0000000A
********************[[[[[ REPORT END ]]]]]********************
8.5 Sensors
This section describes the analog and discrete Sensors available at the ATCA-9405.
Table 8-2 on page 120 , lists the sensor identification numbers and information regarding the
sensor type, name, supported thresholds, assertion and deassertion information, and a brief
description of the sensor purpose.
Table 8-2 ATCA-9405 Specific Sensors
Nr
Sensor
Name Sensor Type
Event/
Reading
Type Event
Data
Byte 1 Event Data
Byte 2 Event Data
Byte 3
Event
Threshold/
Description
Assertion
Deassertion
Rearm
0 Hot Swap
Carrier
Hot Swap
0xF0 Sensor-
specific
discrete
0x6F
0x0
0x1
0x2
0x3
0x4
0x5
0x6
0x7 [7:4] = Cause
[3:0] = Previous
State
FRU ID 0x0: M0
0x1: M1
0x2: M2
0x3: M3
0x4: M4
0x5: M5
0x6: M6
0x7: M7 Assertion Auto