Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 44)

Setup
ATCA-9405 Installation and Use (6806800M71G) 44
2.3.3.3.2 Zone 1 Connector
The Zone 1 connector is used to deliver power from the ATCA back plane to the ATCA-9405
baseboard. The pin out for this connector is defined by the ATCA specifications. The
ATCA-9405 does not implement Metallic Test or Ringing Generator Circuitry and therefore
does not use pins 17 through 24.
Figure 2-7 P10 Backplane Connector Pinout
Table 2-11 Zone 1 Connector P10 Pin Assignment
Contact Destination Description
1 - 4 Reserved Reserved
5 IPMC ISC PC0 Hardware Address Bit 0
6 IPMC ISC PC1 Hardware Address Bit 1
7 IPMC ISC PC2 Hardware Address Bit 2
8 IPMC ISC PC3 Hardware Address Bit 3
9 IPMC ISC PD4 Hardware Address Bit 4
10 IPMC ISC PD5 Hardware Address Bit 5
11 IPMC ISC PD6 Hardware Address Bit 6
12 IPMC ISC PD7 Hardware Address Bit 7