Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 48)

Setup
ATCA-9405 Installation and Use (6806800M71G) 48
2.3.4 Debugging Headers
The following debugging headers are provided on the ATCA-9405. Please note that debugging
headers are only used internally and may be removed later for cost reduction reasons. For more
information regarding location and usage of debugging headers, please contact
sales/marketing team.
Table 2-16 Zone 3 Connector P32 Pin Assignments
Table 2-17 Debugging Header
Location Type Description
JP1 16-pin Header, 1.27mm pitch P2020 debugging header
MSRCID signals and second serial console port (UART1
interface)
JP2 8-pin Header, 1.27mm pitch P2020 Boot Flash header
JP3 3-pin Header, 2.54mm pitch IPMC debug console
JP5 16-pin Header, 1.27mm pitch E10A-USB Emulator header for IPMC
P47 16-pin Header, 1.27mm pitch Packet Processor 1 debugging header
EJTAG support and second serial console port (UART1
interface)
P57 16-pin Header, 1.27mm pitch Packet Processor 2 debugging header
EJTAG support and second serial console port (UART1
interface)