Artesyn ATCA-9405 Installation and Use (May 2014) - Manual (Page 148)

Intelligent Peripheral Management Controller
ATCA-9405 Installation and Use (6806800M71G) 148
8.21 Artesyn OEM Command Set
In addition to standard commands defined by IPMI and PICMG specifications, Artesyn defines
a set of OEM commands to extend the features that Artesyn products may have. Many features
are product-specific; therefore, not all OEM commands are implemented on a product. Refer
to the document of the particular product for the complete command set implemented on the
product.
Artesyn OEM request messages uses NetFn 2Eh and the response messages uses NetFn 2Fh.
8.21.1 Set Serial Output Command
This command allows you to set the serial output source for a particular serial port connector.
Table 8-12 Artesyn OEM Commands
Command CMD Defined in
Set Serial Output 15h 2.20.1
Get Serial Output 16h 0
Set Feature Configuration 1Eh 2.20.3
Get Feature Configuration 1Fh 2.20.4
Table 8-13 Set Serial Output Command
Byte Data field
Request
Data 1 LSB of Artesyn IANA Enterprise Number. A value of
CDh is used.
2 2nd byte of Artesyn IANA Enterprise Number. A value
of 65h is used.
3 MSB of Artesyn IANA Enterprise Number. A value of
00h is used.